Heliformed armor rod

Heliformed armor rod
Feedback form

Armor Rods are intended to protect against bending, compression, abrasion, arc-over, and to provide repair.
The degree of protection needed on a specific line depends upon a number of factors such as line design, temperature, tension, exposure to wind flow, and vibration history on similar construction in the same area. As a general guide, the following recommendations may be adopted to the specific conditions.
Armor Rods are recommended as minimum protection for clamp-type supports or suspensions.
Line Guards are recommended as minimum protection for hand-tied spans. The use of supplementary damping devices, such as Spiral Vibration Dampers, should be considered when conductor vibration is present or expected.

Safety considerations
1.This product is intended for a single (one-time) use and for the specified application.
2. This product is intended for use by trained craftspeople only. This product should not be used by anyone who is not familiar with and trained in the use of it.
3. When working in the area of energized lines with this Product, extra care should be taken to prevent Accidental electrical contact.
4. For proper performance and personal Safety be sure to select the proper size Preformed armor rods before application.
5. Preformed armor rods are precision devices. To insure proper performance, they should be stored in Cartons under cover and handled carefully.
6. The armor rod can use with much fitting.
7. If you have any question please contact with TANHO Electrical Equipment Co., Ltd.

For ACSR conductor


Heliformed armor rod
Repaired armor rods

The repaired armor rod was use for Repair of damaged distribution line phase and neutral conductors.
Damage to distribution line phase and neutral conductor can occur in service for a number of reasons, including:
Aeolian vibration and galloping
Loose hand ties
Lightning strikes
Contact from trees or other objects
Firearms
The re-conductoring is not required. In most cases the repair solution will depend on the extent of the damage.
Therefore, the first step in any repair is an accurate assessment of the level of damage. Generally an accurate assessment of the number of damaged or broken strands can be made by a close visual inspection, with the tension relieved in the damaged area. Since damage can be hidden under ties or support hardware it is usually necessary to carefully remove this hardware to completely assess the amount of damage.
The application steps for electrical repair:
Step 1: Thoroughly wire-brush damaged conductor for the full length of the Armor Rods to be applied.
Step 2: Apply a gritted inhibitor to the full length of this area before applying the repaired Armor Rods.

Feedback Form
Other Products
  • Splices / Sleeves The two piece design ensures strength equivalent to the conductor onto which the fitting is applied.Each fitting is manufactured with internal and external tapers, to eliminate...
  • Connector Parallel groove clamps are mainly used for transmitting current between the interconnected conductors, for example tapping off bus-bars to equipment on substations...
  • Suspension Clamp Suspension clamps are used to connect the conductors to the insulators. The product range comprises products for all purposes. Some of the types have heli-formed rods ...
  • Tension Clamp These requirements do not apply to clamps which are used in switching substations.The components which transmit the compr essive force must be designed so that no...